In an emergency, how to clean up the commodity concrete of concrete truck mixer?
When the failure of cement transit mixer, if it is not timely to sort out the concrete of truck tank, it will be solidification after long period of time, and it will bring us a lot of economic losses. So, do you know how to clean up the cement of cement mixer truck in an emergency?
Method One:
1.Ready to emergency drive hose, the failure of concrete cement mixer truck flameout, unload high-pressure hose connector on the hydraulic motor.
2.Rescue vehicle flameout, its hydraulic motor of high pressure tubing, and corresponding joint and fault in the car with emergency drive connected to the hose.
3.Launch a rescue vehicle, to set the control lever to discharge materials position, the fault in the car commercial concrete is discharge.
4.After the emergency driver, will drive hose to unload, and restore the car to its original state.
Method Two:
1.If the first method has difficulty, you must adopt the following methods, discharge concrete immediately:
Between roller and raceway wedge into the wood, to control the rotation of the mixing drum, must pay attention to safety. Remove the engine flameout, loose a high-pressure tubing, hydraulic motor of the mixing barrel can rotate freely, control the rotation of the mixing drum, make the maintenance hole to the bottom, and then open the hole of maintenance, cleaning out the concrete in the cylinder. At this time must pay attention to safety, commercial concrete after the discharge, recovery of cement concrete truck mixer. Every truck driver have to know at emergency clean cement inside the truck, failure in cement mixer truck, clear in time, will loss to a minimum.
Send your message to us:
Post time: Jul-31-2017